BionX battery repair or refurbish

Réparation ou remise à neuf de la batterie BionX

EbikeBC peut réparer ou remettre à neuf les batteries BionX ainsi que toutes les autres batteries de vélos électriques.

Nous aurons diverses solutions pour le remplacement de la batterie des vélos électriques plus anciens, y compris la batterie BionX ; soit par l'installation de blocs-batteries en boîtier, soit par la remise à neuf du boîtier de batterie existant. Vous devez nous envoyer la batterie et le chargeur existants afin que nous testions et reconditionnions avec une capacité et des performances similaires ou supérieures en utilisant des cellules Li-Ion 18650 de Samsung, LG ou Panasonic.

Le système de gestion de la batterie BionX est intégré au système de contrôle du vélo électrique. Afin de garantir le résultat, nous avons besoin d'avoir la batterie complète, le contrôleur, le système moteur à tester avant et après le remplacement des cellules de la batterie.

Toutes les batteries sont protégées par BMS contre les surintensités, les sous-tensions, les surtensions de charge, l'équilibre de tension des cellules pour assurer la sécurité et la durabilité de la batterie.

Afin de vérifier la faisabilité ou d'obtenir une estimation des coûts, vous devez envoyer les détails suivants :

  • 1- Marque (par exemple BionX)
  • 2- Tension et Capacité (par exemple 48V 8.8Ah)
  • 3- Description du problème
  • 4- Image de la batterie
  • 5- Image de l'étiquette de spécification du chargeur



Envoyer à info@ebikebc.com

ou composez le 604-423-33-81

13 commentaires

Martin

Martin

Hi
I have a bionx 37v 9.6 amps with bms
I let it uncharge to much, and did not find where the batterie alarm was from, tough it was my wifi router 🙂
So basically the battery still work but don’t show the power on the console , it’s discharge faster than before and the regenerative mode doesn’t work either

What could be the price range to fix ?
Thank you

Hi
I have a bionx 37v 9.6 amps with bms
I let it uncharge to much, and did not find where the batterie alarm was from, tough it was my wifi router 🙂
So basically the battery still work but don’t show the power on the console , it’s discharge faster than before and the regenerative mode doesn’t work either

What could be the price range to fix ?
Thank you

eBikeBC

eBikeBC

Unfortunately we don’t have access to controllers and software to fix this issue.

Unfortunately we don’t have access to controllers and software to fix this issue.

Dale godfrey

Dale godfrey

My fried has a Bionx battery 26 v can you repair , or have a use one . or a new one .

My fried has a Bionx battery 26 v can you repair , or have a use one . or a new one .

eBikeBC

eBikeBC

We may be able to replace the internal pack, you need to deliver battery and charger to us. Also make sure the controllers are all functional since we cannot replace or repair BionX controller boards.

We may be able to replace the internal pack, you need to deliver battery and charger to us. Also make sure the controllers are all functional since we cannot replace or repair BionX controller boards.

Roger Crocker

Roger Crocker

I have a Schwinn Invidia . I went to use it this spring and nothing even though the batteries show charged. The switches all check out. It has 2battery packs. Each pack has 2 UB12100-ASk Universal Batterry. Other info on it is 12100. 12 v, 10Ah.
Can batteries be defected even though showing a charge.

I have a Schwinn Invidia . I went to use it this spring and nothing even though the batteries show charged. The switches all check out. It has 2battery packs. Each pack has 2 UB12100-ASk Universal Batterry. Other info on it is 12100. 12 v, 10Ah.
Can batteries be defected even though showing a charge.

eBikeBC

eBikeBC

You need to check batteries with Voltmeter to measure Voltage. Yet you cannot confirm the battery health unless you test it under a consumer load similar to your ebike current rating. There might be disconnection, fuses or broken controllers if batteries are fine. Never judge battery condition by charger indicators. They may show full when battery is dead.
You need to take the system to an electrician.

You need to check batteries with Voltmeter to measure Voltage. Yet you cannot confirm the battery health unless you test it under a consumer load similar to your ebike current rating. There might be disconnection, fuses or broken controllers if batteries are fine. Never judge battery condition by charger indicators. They may show full when battery is dead.
You need to take the system to an electrician.

Michael R.

Michael R.

Can you replace cells in a 48v 11.6a BionX battery specially designed for an Elby?

Can you replace cells in a 48v 11.6a BionX battery specially designed for an Elby?

eBikeBC

eBikeBC

Technically doable, but too risky. We may be stuck if we lose any of the electronic circuit boards by any mistake.

Technically doable, but too risky. We may be stuck if we lose any of the electronic circuit boards by any mistake.

Michael Gelber

Michael Gelber

I have a 2019 RadRover bike. The battery ran down after being used for only 623km because it was left after the owner died. Can you bring it back to life? And how much would it cost?

I have a 2019 RadRover bike. The battery ran down after being used for only 623km because it was left after the owner died. Can you bring it back to life? And how much would it cost?

eBikeBC

eBikeBC

There might be a chance to revive the battery pack, if the cells are not seriously harmed.

There might be a chance to revive the battery pack, if the cells are not seriously harmed.

Dave

Dave

Hi I have a Bionx 48v 6.6 317wh battery that is only giving me about 10 km on a full charge. Is it underperforming? I am not going up many hills mostly flats . Any help ? How much to re pack. Thanks

Hi I have a Bionx 48v 6.6 317wh battery that is only giving me about 10 km on a full charge. Is it underperforming? I am not going up many hills mostly flats . Any help ? How much to re pack. Thanks

Real Blais

Real Blais

Hello have a dead 37 volts bionx battery ,can i replace it for a 48 v bionx and new charger.

Hello have a dead 37 volts bionx battery ,can i replace it for a 48 v bionx and new charger.

Ron Fay

Ron Fay

My wife has a Toba Edwin with a 37V bionx battery (looks like a proprietary case for the bike manufacturer, but everything else is Bionx). Get a red flashing light turning to solid red when hooking up to charger and “POWR PROT” on the screen. Tried to pedal to recharge enough so the charger works like the bicycle shop showed me and nothing. Options on this?

My wife has a Toba Edwin with a 37V bionx battery (looks like a proprietary case for the bike manufacturer, but everything else is Bionx). Get a red flashing light turning to solid red when hooking up to charger and “POWR PROT” on the screen. Tried to pedal to recharge enough so the charger works like the bicycle shop showed me and nothing. Options on this?

Laisser un commentaire

Tous les commentaires sont modérés avant d'être publiés.

Ce site est protégé par reCAPTCHA, et la Politique de confidentialité et les Conditions d'utilisation de Google s'appliquent.

Continuer à lire

Produits susceptibles de vous plaire

Economisez $799.31
D35D35
D35
Prix de venteA partir de $1,996.30 CAD Prix normal$2,795.61 CAD
ZERO 10X - Scooter électrique à deux roues motricesZERO 10X - Scooter électrique à deux roues motrices
ZERO 10X - Scooter électrique à deux roues motrices
Prix de venteA partir de $2,199.00 CAD
D35 Kit complet de conversion eBike 350W
Vélos avec cadre capable d'installer une batterie de tube diagonal
Prix de vente$0.00 CAD
Economisez $799.31
envo lynx20 electric bike in side viewenvo lynx20 electric bike in front view
Lynx 20"
Prix de venteA partir de $1,596.64 CAD Prix normal$2,395.95 CAD